Condensed Operating Instructions - Fisher Labs CZ-21 QuickSilver Operating Manual

CONDENSED OPERATING INSTRUCTIONS

Factory Pre-Set "Turn-On-and-Go" Marks
Your CZ-21 QuickSilver is simple to operate. Even so, we strongly
recommend that you read this entire manual. You'll be able to
tune your CZ-21 to your specific needs and conditions.
Figure 1. Factory pre-set turn-on-and-go marks (circled in red or
blue on your CZ-21 control panel) can get you up and running
immediately.
Pre-set Audio
Boost mark
at "5"
Pre-set
DISCRIMINATION
at "4"
1. Set all the controls to the red "Turn-On-and-Go"
This puts you in a "coins-only" mode, and you're ready
pre-set:
GROUND
DISC
SENSITIVITY = 3
VOLUME
to start searching. Keep in mind that the GROUND
setting of "5" is probably not the optimum setting
for the ground you're searching. The sensitivity level
is set low to reduce false signals caused by ground
mineralization.
= 5
= 4
= 5
Salt-water Pre-set
SENSITIVITY at "3"
Fresh-
water
sensitivity
Pre-set
at "7"
Pre-set
GROUND at "5"
3