Pinpointing - Fisher Labs CZ-21 QuickSilver Operating Manual

PINPOINTING

Target location is quick and easy using the touch pad pinpoint
mode. The coil does not have to be moving to get a response in
this mode.
1. Whether in Autotune or Target I.D. mode, once the
2. As you bring the coil back into the target area, the
3. When the pitch and volume are at their highest
4. Repeat one more time, side to side and front to back,
NOTE: Large or shallow targets can give a wide signal in pinpoint
mode. This can make pinpointing difficult. To pinpoint these large
or shallow targets, find the edge of the wide signal in pinpoint
mode. While over the edge of the signal, tap the pinpoint button
again. This automatically decreases the sensitivity and narrows
the width of the pinpoint signal. By repeating this procedure a
few times over the edge of the wide signal, you can narrow the
pinpoint signal and pinpoint your target.
22
presence of a target is indicated by the "beep-
beep" of your CZ-21, simply move the coil away
from the target area, and with the coil lightly on
the ground or very close to it, press the PINPOINT
button.
audio volume and pitch will increase.
points, stop the coil and move it forward and
backward a couple of times, again stopping over
the strongest response.
stopping over the spot where you get the maximum
volume and pitch.