Turn On Procedure; Ground Balancing - Fisher Labs CZ-21 QuickSilver Operating Manual

CONTROL PANEL
5. PINPOINT: Activating the PINPOINT feature with the center-

GROUND BALANCING

When your CZ-21 QuickSilver is properly "ground balanced,"
it will have only a minimal response to ground mineralization.
Precise adjustment of the GROUND control is critical for optimum
performance. The higher the degree of ground mineralization or
the higher the sensitivity setting, the more critical it is to have your
machine properly ground balanced. Once you adjust it in either
the Autotune mode or Target-I.D. mode, you can switch back and
forth between the two modes without resetting. Recheck your
setting occasionally as you search because ground conditions
often change rapidly.
If you have difficulty ground balancing, try reducing your sensitivity
level or moving to another spot just in case you are over a buried
piece of metal. In some areas of high ground mineralization you
may not be able to use the touch pad method.
battery strength.
GOOD BATTERIES: Loud, high pitched tone
WEAK BATTERIES: Soft, low pitched tone or "ticking" sound
BATTERIES NEED REPLACING: No tone
During use, the speaker volume will fade and become
nearly inaudible before the detector performance is
compromised by weak batteries.
positioned button enters a NO-MOTION detection mode. In
this mode of operation, the detector will emit a monotone
hum whenever metal enters the coil's field of detection.
To use pinpoint, PRESS the button. The pinpoint button will
not deflect with pressure; you will feel no movement in
the button. A 2nd press of
the button will return you
to your previous motion
detection mode.
A moderate pressure,
applied briefly to the
center of the button, is
required.
The button requires a
2-second wait between
presses.
11