Fisher Labs CZ-21 QuickSilver Operating Manual page 11

SETTING UP
Hold unit firmly and separate handle, being careful not to drop
the control unit and damage it. Place unit battery side down with
battery cover on table top, or a flat stable surface and grasp the
unit firmly in one hand and the handle grip firmly in the other.
"Hipmounting" the CZ-21 in this manner takes about half the weight
off the handle and allows the land or shallow-water treasure hunter
to search much longer without arm fatigue.
1. Slide the belt clip into grooves on the bottom of the
2. Unwrap just enough of the coil cable to allow for
3. Slip the control housing onto your belt, left side for
NOTE: Because of the extreme sensitivity of the CZ-21 search coil,
hipmounting the control housing may produce a false signal when
the search coil reaches the end of its arc (on the side that the
control box is attached to your belt). Depending on your stem
length and how high you have the housing hipmounted, the
search coil may actually detect the housing.
WARRANTY NOTICE:
Damage to coil cable at housing connection is not warrantable if
damaged by excessive force.
If hipmounting, please leave slack in the cable so as not to yank
the cable from the housing at the end of your sweep.
control housing. This is a snug fit, and you'll have to
bend the clip slightly.
searching.
right handers, right side for left handers.
9