Grizzly G1067Z Instruction Manual page 9

2.
Bolt the upper mount plate and the short
stand support to each end assembly using
the 5 ⁄ '' - 18 x 3 ⁄
16 4
Figure 2.
Figure 2.
3. Attach the long stand supports to each end
assembly using the
bolts provided. Figure 3.
Figure 3.
-8-
'' carriage bolts provided.
5 ⁄ '' - 18 x 3 ⁄ '' carriage
16 4
4.
With an assistant, set the lathe bed assem-
bly on the stand, orienting the front of the
headstock with the switch opening in the
stand leg. Bolt the lathe bed to the stand
using the eight 5 ⁄
16
and Hex Nuts supplied and tighten down.
Figure 4.
Figure 4.
5. At this point tighten down all the bolts on the
stand. It is a good idea to do this with the
lathe set in place where it will be used.
'' - 18 x 1 1 ⁄ '' Cap Screws
4
G1067Z Wood Lathe