System Connections - Sharp XL-E171DVH Instructions Manual

System connections

Make sure to unplug the AC power lead before making any connections.
Right
speaker
■ Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and
position the FM aerial wire in the direction where the
strongest signal can be received.
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
■ Speaker connection
● Connect the black wire to the
minus (–) terminal, and the red
wire to the plus (+) terminal.
● Use speakers with an impedance
of 4 ohms or more, as lower
impedance speakers can damage
the unit.
● Do not mistake the right and the
left channels. The right speaker is
the one on the right side when you
face the unit.
● Do not let the bare speaker wires touch each other.
● Do not allow any objects to fall into or to be placed in
the bass reflex ducts.
● Do not stand or sit on the speakers. You may be
injured.
FM aerial
Incorrect
E-7
Video cable
(not supplied)
To video input socket
Label is located at the
bottom of the unit.
■ Demonstration mode
● The first time the unit is plugged in, the unit will enter
the demonstration mode.
● To cancel the demonstration mode, press the DEMO/
DIMMER button (remote control) during power stand-
by mode. The unit will enter the low power consumption
mode.
● To return to the demonstration mode, press the DEMO/
DIMMER button again.
■ AC power connection
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
socket.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
TV
Left
speaker
Red
Black
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)