Sharp XL-E171DVH Instructions Manual page 34

Timer and sleep operation (Remote control only) (continued)
■ Timer playback
Before setting timer:
● Check that the clock is set to the correct time (refer to
page 15). If it is not set, you cannot use the timer
function.
● For timer playback: Plug in USB or load discs to be
played.
1
Press the ON/STAND-BY button to turn the power on.
2
Press and hold the CLOCK/TIMER button.
3
Within 10 seconds, press the
select "Once" or "Daily", and press the ENTER button.
4
Within 10 seconds, press the
select "Timer Set", and press the ENTER button.
5
To select the timer playback source (DISC, TUNER,
USB VIDEO/AUDIO, AUDIO IN, LINE IN), press the
or button. Press the ENTER button.
When you select the tuner, select a station by pressing
the or button, and then press the ENTER
button. If a station has not been programmed, "No
Preset" will be displayed and timer setting will be
cancelled.
6
To adjust the day, press the
press the ENTER button.
7
Press the ENTER button to adjust the hour. Press the
or button and then press the ENTER button.
8
To adjust the minutes, press the
then press the ENTER button.
9
Set the time to finish as in steps 7 and 8 above.
10
Adjust the volume using the VOLUME control, and then
press the ENTER button. Do not turn the volume up too
high.
11
Press the ON/STAND-BY button to enter the power
stand-by mode. The "TIMER" indicator lights up and
the unit is ready for timer playback.
12
When the preset time is reached, playback will start.
The volume will increase gradually until it reaches the
preset volume. The timer icon will blink during timer
playback.
or button to
or button to
or button and then
or button and
E-34
13
When the timer end time is reached, the system will
enter the power stand-by mode automatically.
Once timer:
The timer will be cancelled.
Daily timer:
The timer operates at the same time every day. It will
continue until the daily timer setting is cancelled. Cancel
the daily timer when it is not in use.
Notes:
● When performing timer playback using external unit
connected to the USB terminal or AUDIO IN jack or
"LINE IN" connector, select related source in step 5.
● This unit will turn on or enter the power stand-by mode
automatically. However, the connected unit will not turn
on or off. To stop the timer playback, follow step
"Cancelling the timer setting" of this page.
Checking the timer setting:
1
Turn the power on and press and hold down the
CLOCK/TIMER button.
2
Within 10 seconds, press the
"Once" or "Daily", and press the ENTER button.
3
Within 10 seconds, press the
"Timer Call", and press the ENTER button.
Cancelling the timer setting:
1
Turn the power on and press and hold down the
CLOCK/TIMER button.
2
Within 10 seconds, press the
"Once" or "Daily", and press the ENTER button.
3
Within 10 seconds, press the
"Timer Off", and press the ENTER button. Timer will be
cancelled (the setting will not be cancelled).
Reusing the memorised timer setting:
The timer setting will be memorised once it is entered. To
reuse the same setting, perform the following operations.
1
Turn the power on and press and hold down the
CLOCK/TIMER button.
2
Within 10 seconds, press the
"Once" or "Daily", and press the ENTER button.
3
Within 10 seconds, press the
"Timer On" , and press the ENTER button.
4
Press the ON/STAND-BY button to enter the power
stand-by mode.
or button to select
or button to select
or button to select
or button to select
or button to select
or button to select