Lubricating Sleeve Bearings - Grizzly H7761 Owner's Manual

Lubricating Sleeve
Bearings
Lubricate the sleeve bearing with 30 WT oil every
10 hours of operation. No other lubrication is nec-
essary for this machine.
To lubricate the sleeve bearings:
1. DISCONNECT THE MACHINE FROM THE
POWER SOURCE!
2. Remove the sanding belt.
3. Apply two or three drops of oil in the hole at
the end of the idler pulley (Figure 15).
4. Wipe of any residual oil.
Note: DO NOT apply extra oil. Too much oil
can cause the belt to slip.
Figure 15. Lubricating the sleeve bearings.
-22-
H7761 2" x 27" Belt & 6" Disc Combo Sander