Coolant - Yamaha FZ6RB(C) Owner's Manual

U36P13E0.book Page 16 Tuesday, July 5, 2011 8:45 AM
PERIODIC MAINTENANCE AND ADJUSTMENT
10. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
TIP
After the engine is started, the engine
oil level warning light should go off if the
oil level is sufficient.
NOTICE
If the oil level warning light flickers
or remains on even if the oil level is
correct, immediately turn the engine
off and have a Yamaha dealer check
the vehicle.
7
11. Turn the engine off, wait a few min-
utes until the oil settles, and then
check the oil level and correct it if
necessary.
12. Install the cowling.

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on a level sur-
ECA10401
face.
2. Remove cowling A. (See page
7-9.)
3. Hold the vehicle in an upright posi-
tion.
TIP
● The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
●
Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
4. Check the coolant level in the cool-
ant reservoir.
7-16
EAU20070
TIP
The coolant should be between the
minimum and maximum level marks.
2
EAU47331
3
1. Coolant reservoir
2. Maximum level mark
3. Minimum level mark
5. If the coolant is at or below the
minimum level mark, remove cowl-
ing C. (See page 7-9.)
6. Remove the coolant reservoir
breather hose from the guide, and
then remove the coolant reservoir
cap.
1