Yamaha FZ6RB(C) Owner's Manual page 26

U36P13E0.book Page 6 Tuesday, July 5, 2011 8:45 AM
INSTRUMENT AND CONTROL FUNCTIONS
Tachometer
1
4
1. Tachometer
2. Tachometer red zone
The electric tachometer allows the rider
to monitor the engine speed and keep it
within the ideal power range.
When the key is turned to "ON", the ta-
chometer needle will sweep once
across the r/min range and then return
to zero r/min in order to test the electri-
cal circuit.
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 11666 r/min and above
Clock
1
2
1. Clock
The clock displays when the key is
turned to "ON". In addition, the clock
can be displayed for 10 seconds by
pushing the "SELECT" button when the
main switch is in the "OFF" or "LOCK"
position.
To set the clock
1. Turn the key to "ON".
ECA10031
2. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
3. When the hour digits start flashing,
push the "RESET" button to set the
hours.
4. Push the "SELECT" button, and
the minute digits will start flashing.
4-6
5. Push the "RESET" button to set
the minutes.
6. Push the "SELECT" button and
then release it to start the clock.
Odometer and tripmeter modes
1
1. Odometer/tripmeter/fuel reserve tripmeter
Push the "SELECT" button to switch
the display between the odometer
mode "ODO" and the tripmeter modes
"TRIP A" and "TRIP B" in the following
order:
TRIP A → TRIP B → ODO → TRIP A
When the fuel amount in the fuel tank
decreases to 3.2 L (0.85 US gal,
0.70 Imp.gal), the left segment of the
fuel meter will start flashing, and the
odometer display will automatically
change to the fuel reserve tripmeter