Replacement Parts - Vector Jump ‘n Charge VEC12B Owner's Manual

12v battery charger and jump start system

Hide thumbs

Table Of Contents

Table of Contents

CHARGER CONTROLS AND INDICATORS

Figure 3 shows the charger control panel of the

consists of:

Digital Display - Displays F F U U L L when battery is fully charged, and displays the Fault

Polarized Plug - use with most household extension cords.

pushbutton

2/4/6 Amp

ON/OFF pushbutton - Selects Off/On

Power LED - when lit indicates AC is applied to charger.

Fault LED - when lit indicates one or more abnormal conditions exist.

Alternator Good

NOTE: Each time the charger rate is changed, the charger sounds a beep. The only

time the selected charge rate does not display at the full selected rate is when

the battery is nearly full and charging at either steps two or three. The display

will show a slow charge rate. To return to 2 Amp setting, press the 2/4/6 Amp

button. When the battery is fully charged, "FUL" will be displayed .

NOTE: Small 12 volt DC batteries such as those used in motorcycles, garden tractors,

ATVs, jet skis, and snowmobiles can be damaged by high charge rates.

ALWAYS select the 2 Amp setting to charge this type of battery. For slower

charging time on larger batteries, select the 2 Amp setting.

ALTERNATOR CHECK PROCEDURE

NOTE: DISCONNECT THE 110/120V AC FOR THIS FUNCTION

Connect positive (+) red clamp to vehicle battery's positive terminal.

Connect negative (-) black clamp to vehicle battery's negative terminal.

Press ON/OFF pushbutton to turn unit on.

Press 'Alternator Check' pushbutton. The digital display will show bars.

5. After approximately 15 seconds, Alternator Good LED will illuminate.

6. If 'Fault' indicator lights, the alternator is not in good working condition and

should be replaced.