VEC020C JUMP-START SYSTEM, AIR COMPRESSOR AND POWER SUPPLY Portable, Cordless, Rechargeable 12 Volt DC OWNER’S MANUAL & WARRANTY INFORMATION THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USING, READ AND UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND PRODUCT LABELS, PLUS YOUR VEHICLE’S BATTERY MANUFACTURER GUIDELINES.
To avoid possible damage that may shorten the unit’s working life, protect it from direct sunlight, direct heat and/or moisture. 10) Check unit periodically for wear and tear. Replace worn or defective parts immediately contact Vector customer service department at (954) 584-4446.
AIR COMPRESSOR and 12 VOLT DC POWER SUPPLY. This compact jumpstarter is unique in the amount of energy it can supply for it’s size. The internal battery is a Vector-developed high density sealed lead acid battery that stores and delivers energy comparable to full sized ordinary jumpstarters.
6. Check unit periodically for wear and tear. Replace worn or defective parts immediately - contact Vector Customer Service Department at (954) 584-4446 ext.19, toll-free: (954) 584-5504 or through our internet address: www.vectormfg.com.
7. Do not attempt to jumpstart a frozen battery. 8. NEVER submerge this unit in water. 9. Do not wear vinyl clothing when jumpstarting a vehicle-friction can cause dangerous static electricity sparks. Remove all jewelry or metal objects-they can cause short circuits or react with battery acid to cause severe burns.
POSITIVE GROUND SYSTEMS: NOTE: In the rare event that the vehicle to be started has a Positive Grounded System (positive battery terminal is connected to chassis): Replace step 4 and 5 above with steps, 4a and 4b and then proceed to steps 6 through 8 below. 4a.
110/120-VOLT AC CHARGING IMPORTANT: • MAKE SURE ALL SWITCHES ARE TURNED OFF DURING RECHARGING • Charge unit for full 24 hours, prior to first use • Recharge unit fully after each use • Recharge unit every two months, when it has not been used CAUTION: Make sure compressor switch is off otherwise the battery will not accept the charge.
OPERATION AS A 12 VOLT PORTABLE POWER SUPPLY NOTE: Make sure that the unit ‘s Safety ON/OFF switch is ALWAYS in the OFF position when using the 12 Volt DC accessory outlet. 1. Lift up the cover of the unit‘s 12 Volt DC cigarette lighter-type accessory receptacle (See Figure 1). 2.
COMPRESSOR USE IMPORTANT: Read Instructions Carefully To Avoid Possible Injury Or Property Damage. The compressor may be used by removing the air hose from it’s storage channel and if required, fitting an appropriate nozzle to the air hose. An On/Off switch located on the side of the unit controls the power to the compressor and the gauge light.
5. Snap the lens cover back into place. 6. Replace (clockwise) the screws and carefully tighten. Do not over tighten! BATTERY REPLACEMENT It is recommended that the unit be returned to Vector Customer Service for battery replacement: Contact (954) 584-4446 or toll-free (866) 584-5504 ext.19. WARNINGS: •...
Vector Manufacturing, Ltd., regarding this product. There is no other warranty, other than those described herein. This Vector Manufacturing, Ltd. product is warranted, to the original purchaser only, to be free of defects in materials and workmanship for 120 days from the date of purchase without additional charge. This warranty may be extended to two years from date of purchase by paying an Extended Warranty fee (see below).
Need help?
Do you have a question about the Start-It Compact Pro VEC020C and is the answer not in the manual?
Questions and answers