Vector Jump ‘n Charge VEC12B Owner's Manual page 12

WARNING
• Do not dispose of the battery in fire as this may result in an explosion
• Before disposing of the battery, protect exposed terminals with heavy-duty
electrical tape to prevent shorting (shorting can result in injury or fire)
• Do not expose battery to fire or intense heat as it may explode
Battery Disposal:
This unit contains a maintenance-free, non-spillable, sealed
lead-acid battery. This battery is fully recyclable and should be
accepted at any location that accepts common automotive
starter batteries. Examples of places that accept these batteries
are: County or municipal recycling drop-off centers, scrap metal
dealers and retailers who sell automotive replacement lead acid
starter batteries. For more information on recycling this battery,
call toll-free (877) 288-7722.
12 Volt DC
Power Source
JUMP 'N CHARGE CONTROLS AND INDICATORS
Figure 2 shows the Jump 'n Charge system control panel, and consists of:
• Four Battery Level Status LEDs indicating Low to High levels of battery level status
• Battery Level Status (PUSH) button lights LEDs above.
• Good Connection Light indicates a good clamp and terminal connection.
• Reverse Connection Light indicates the clamps are reversed.
• 12 Volt DC Power Source Outlet for use with 12 volt DC appliances and recharge
from vehicle battery
Figure 2 - Jump 'n Charge Controls and Indicators
Reverse Connection Light Good Connection Light
Battery
Level Status
PUSH Button
11
ALWAYS RECYCLE
Four Battery
Level Status
LEDs