Installation; Unpacking; Positioning; Cleaning - Linn Majik DS Owner's Manual

MAJIK DS
OWNER'S MANUAL

INSTALLATION

For full installation instructions see the System Installation and Setup Manual
on the supplied CD-ROM.
Important:
The Majik DS player must be installed by an engineer/technician trained
in networks and network security. Linn Products Limited cannot be held
responsible for any network security compromise and/or loss of data due to
improper installation.

Unpacking

The Majik DS player is supplied with the following:
• handset
• 2 x AAA batteries for the handset
• 1 pair of black interconnect cables
• RS232 lead
• mains lead
• CD-ROM (contains system software, installation manual and
owner's manual)
We recommend that you retain all packaging in case you need to transport
the Majik DS at a later date.

Positioning

You can position your Majik DS almost anywhere you find convenient, but
please consider the following points:
• The unit should be placed on a flat, stable and rigid surface.
• Do not position the unit where sunlight can shine (whether directly,
diffused or reflected) on its display as the infra-red (IR) radiation in sunlight
will be picked up by the unit's IR remote sensor and this can adversely
affect its operation. Similarly, some electrical devices such as plasma TVs,
fluorescent lights and energy saving lamps can emit IR which can likewise
affect the operation.
• For best performance do not stack the unit with other products. Ideally,
position the unit on a shelf by itself or, if proximity to other products is
unavoidable, positioning side-by-side is preferable to stacking.
• The unit should not be situated above, or directly adjacent to, sources of
heat such as radiators, power amplifiers, etc. Nor should it be enclosed in
a cabinet with such devices.
• The unit itself produces very little heat; however it is advisable to allow a
little space to the sides, rear and above the unit (ideally 10 cm / 4") for air
circulation which will allow any heat to dissipate.

Cleaning

Disconnect the Majik DS from the power supply before cleaning. Remove
dust and fingerprints with a soft, dry cloth.

Connecting to the mains supply

The Majik DS contains an automatic internal mains voltage switch. This
switch operates on all worldwide mains voltages from 100 V to 240 V. The
unit can be connected to any worldwide mains voltage with no adjustment.
This unit must be earthed. Use the earthed moulded mains lead supplied,
or if no mains earth is available, ensure the product's EARTH GROUND
connector is connected to an earthing terminal.
2
www.l i n n.c o. uk