Spa Maintenance; Cleaning The Filter - Jacuzzi J-210 Owner's Manual

Economy Filtration/Heating Modes (F4-F6)
F4 4 hours of filtration/heating per day (one 2-hour cycle
every 2 hours).
F5 6 hours of filtration/heating per day (one 2-hour cycle
every 8 hours).
F6 8 hours of filtration/heating per day (one 2-hour cycle
every 6 hours)
Lock Modes (L1-L2)
L1 Lock out (disables all spa functions to permit filter
cleaning)
L2 Lock Mode (disables the jets and light buttons to pre vent
unauthorized use of spa). Filtration/heating cycle will
continue to operate as programmed in this mode. The
temperature display flashes when this function is enabled. Example:
the "F3" filtration/heating cycle was enabled prior to choosing lock
mode. The spa continues to perform the "F3" cycle until lock mode
is canceled, allowing another cycle to be selected.
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. Example: If you desire
your first filtration/heating cycle to begin at 0:00 AM turn off power
to the spa and turn it back on again at 9:58 AM. Note: start time is
approximate and may vary slightly from day to day.

12.0 Spa Maintenance

Proper and regular maintenance of your spa will help it retain its beauty
and performance. Your authorized Jacuzzi dealer can supply you with
all the information, supplies, and accessory products you will need to
accomplish this.

12.1 Cleaning The Filter

Your Jacuzzi spa is equipped with a skimmer basket and filter cartridge
located in the skimmer/filter well. Filtering is accomplished when jets
pump # turns on in low speed initiating water flow through the skimmer
basket and polyester mesh filter cartridge. As this happens, suspended
particles become trapped on the filter's surface. To ensure optimum
performance, it is necessary to remove and clean the skimmer basket
and filter cartridge regularly (typically once a week) depending on usage
and water quality.
page 25