Computer Input; Input Source Selection - Sanyo PLC-XL51A Owner's Manual

Computer Input

Input Source Selection

Direct Operation
Press the INPUT button on the top control to select either
Computer 1 or Computer 2, or press the COMPUTER 1 on
the remote control to select Computer 1 button or press
the COMPUTER 2 button on the remote control to select
Computer 2.
Before using the INPUT or COMPUTER 1 / 2 buttons,
select the correct input source through Menu operation as
described below.
Menu Operation
Press the MENU button to display the On-Screen
1
Menu. Use the Point
frame pointer to the Input Menu icon.
Use the Point
ed
2
pointer to either Computer 1 or Computer 2, and then
press the SELECT button.
After the Source Select Menu appeared for Computer
3
1, move the pointer to RGB and then press the
SELECT button.
✔Note:
•Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is set as Monitor out (p.49).
•Computer 2 (COMPUTER IN 2/MONITOR OUT) can
accept only the RGB signal.
• Wired and Wireless are for the Network function. See
owner's manual "Network Set-up and Operation" .
buttons to move the red
7 8
buttons to move the red arrow
Top Control INPUT button
Remote Control
COMPUTER 1 button
COMPUTER 2 button
*See Notes at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red arrow)
to Computer 1 and press the
SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB
and press the SELECT
button.
Input Menu
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
INPUT button
Computer 1
Computer 2*
Video
Wired
Wireless
27