Prepare The Radio Box - AquaCraft Top Speed 2 HCAB5010 Assembly And Operation Manual

PREPARE THE RADIO BOX

❏
1. Use CA glue or epoxy to attach the servo tray atop the
servo tray supports as shown. The servo tray supports have
already been glued in place for you.
❏
2. Study the image above. Use a felt-tip pen to make
marks at the end of the radio box with the servo tray
following the dimensions shown.
❏
3. Use a drill with a 3/8" [9.5mm] drill bit* to make two (2)
holes in the radio box for the steering linkages at the end of
the radio box with the servo tray. Keep the plastic pushrod
seal flanges nearby to test fit them.
*TIP: A body reamer can be used instead. Just be sure to
check the size of the hole often and be careful not to make
the opening too large. If using a drill bit, be careful not to
"blow" out through the wood inside the box.
❏
4. Use a drill with a 7/32" [6mm] drill bit (or use a body
reamer) to make a hole for the throttle linkage at the end of
the radio box with the servo tray. Keep the rubber throttle
pushrod seal nearby for test fit.
❏
5. Carefully put a bead of CA glue around the inside edge
of the two (2) plastic pushrod seal flanges and insert them
from inside the box as shown.
❏
6. Carefully put a bead of CA glue around the two (2)
rubber pushrod seals and fit them over the flanges as
shown. It is important to have a good seal to prevent water
from entering the radio box.
8