Final Assembly Instructions; The Boat Stand; Remove The Canopy; Install The Engine - AquaCraft Top Speed 2 HCAB5010 Assembly And Operation Manual

FINAL ASSEMBLY INSTRUCTIONS

Carefully remove your Top Speed 2 and stand from the box.
Carefully remove all remaining parts bags from the box. You
may wish to keep the box in order to more easily
transport and store your Top Speed 2.
Decals have been provided for your Top Speed 2.
Simply cut them out, peel, and stick! See the photos on
the box for a decal placement example.

THE BOAT STAND

Your display stand doubles as a start and set-up stand.
Simply put, when the stand is placed so that the narrow side
is up, the stand is ready to assist in servicing your outboard
engine during start-up to help prevent stripping out your
steering servo gears. Be sure your engine is in the start slot
during start-up. When the wide side of the stand is placed
up, the stand is in "set-up" position and will allow you to
easily adjust the prop depth and thrust angle of the engine.

REMOVE THE CANOPY

❏
1. Locate and remove the body clip and nylon washer at
the rear of each side of the cowl as shown.
TIP: Use CA glue to attach the nylon washers in place at the
rear of the cowl as shown. This will eliminate one step from
removing the cowl and make it easier to keep track of the
nylon washers. You may also want to tether the body clips to
the cowl with fishing line.
❏
2. Carefully pull the sides over the body posts and lift the
canopy free of the hull.

INSTALL THE ENGINE

You can use any .21cu in [3.5cc] outboard engine that you
want. We have provided instructions and templates for two
of the most widely used engine brands currently available.
The O.S. Max 21 XM Outboard Engine
In order to secure the O.S. Max 21 XM to the transom at the
correct propeller depth, the mounting plate will need to be
inverted. The exploded view of the engine on page 9 of the
O.S. .21 XM manual will help identify parts.
5