To reduce the risk of overheating and possible damage to other equipment, do not use this product to control loads in excess of the specified maximum(s) or, install in locations with electricity specifications which are outside of the product’s specifications. Page 3 of 6 X10AM466 Rev: 10/7/2011 6:32 PM...
3) Once X10 Appliance Module is plugged in, continue to hold down the Set button for 3 seconds, then release X10 Appliance Module’s LED will turn on solid and the load will turn on Specifications View specifications for X10 Appliance Module at: www.smarthome.com/X10AM466.html Page 4 of 6 X10AM466 Rev: 10/7/2011 6:32 PM...
This product has been thoroughly tested by ITS ETL SEMKO, a nationally recognized independent third-party testing laboratory. The North American ETL Listed mark signifies that the device has been tested to and has met the requirements of a widely recognized consensus of U.S. and Canadian Page 5 of 6 X10AM466 Rev: 10/7/2011 6:32 PM...
Need help?
Do you have a question about the X10AM466 and is the answer not in the manual?
Questions and answers