X10 Toggle Dimmer Switch ........................3 Features & Benefits ........................... 3 What’s in the Box?............................. 3 Getting Started ............................4 Identifying the Electrical Wires in your Home.................... 4 Installation ..............................5 Setting the X10 Address..........................6 Removing the X10 Address........................6 Using X10 Toggle Dimmer Switch......................
This elegant and full-featured switch gives you local control and X10 capabilities for the connected light. Remotely turn the light on and off from an X10 controller or send commands to other X10 devices when you use X10 Toggle Dimmer Switch’s toggle. You can also preset an On-Level so the load will fade into the perfect brightness level every time you turn it on from the toggle.
If you are having any difficulties, consult an electrician. If you are not knowledgeable about, and comfortable with, electrical circuitry, you should have a qualified electrician install X10 Toggle Dimmer Switch for you. If you have any questions, please consult an electrician.
5) Ensure the wires are firmly attached and that there is no exposed copper except for the GROUND wire 6) Gently place X10 Toggle Dimmer Switch into the junction box, orienting the unit with the LED at the bottom and screw into place...
1) Press & hold X10 Toggle Dimmer Switch’s Set button until X10 Toggle Dimmer Switch beeps X10 Toggle Dimmer Switch’s LED will begin blinking 2) Using an X10 controller, send the X10 address you want to assign followed by the ON command three times.
2) Press & hold X10 Toggle Dimmer Switch’s Set button until X10 Toggle Dimmer Switch beeps again X10 Toggle Dimmer Switch’s LED will continue blinking 3) Press & hold X10 Toggle Dimmer Switch’s Set button until X10 Toggle Dimmer Switch beeps a third time X10 Toggle Dimmer Switch’s LED will stop blinking and turn on solid...
X10 Toggle Dimmer Switch The LED and the load will turn off 2) Wait 10 seconds, and then push the Set button in as far as it will go and hold until X10 Toggle Switch beeps A few seconds after you release the Set button, X10 Toggle Dimmer Switch will double-beep and...