Bunn My Café AP Installation & Operating Manual page 11

BREW LOCKOUT (YES/NO)
Setting to "YES" will only allow brews at or above the
"SET READY" temp screen.
BREW OZ. (A/B) (1-16)
Adjust brew volume.
BREW METER (A/B) (1-5)
Simplifi ed pulse brew adjustment.
1=Preinfusion. 2-5=pulse brew, 2 being the shortest
pulse brew cycle, 5 the longest pulse brew cycle.
ENTER SERVICE #
Program service phone number to be displayed anytime
there is a fault message.
ENTER PASSWORD
User must enter a 3 digit number to access remainder
of adjustments. If no number has been pre programmed
(0 0 0), then access is allowed.
SET PASSWORD (001-999)
Program any three digit number as a password.
SET LANGUAGE
Choose between English or Spanish.
UNITS
Choose between English or metric.
SET TEMP
Adjust tank temperature 185 to 205° F (85 to 96° C)
SET READY
Sets the minimum temperature allowable to start a brew
cycle. Range: (2° to 20° F) or (2° to 10° C) below the
set temperature.
HOT H2o LOCKOUT
Setting to "YES" will only allow dispensing of hot water
at or above the "H2o READY" temp screen.
HOT H2o READY
Sets the minimum temperature allowable to start dis-
pensing hot water.
PROGRAM OVERVIEW
ENTER ASSET #
This function allows the you to enter in an optional asset
number. This can be useful for tracking the usage or
service of an individual machine within a group.
SET PULSE BREW (A/B)
Individually adjust on/off times.
AIR TIME (A/B) (1-25)
Time the brew tank is purged at the end of each brew
cycle.
BREWS TO EMPTY (OFF/15-25)
Set number of used pods in bin to turn on "EMPTY
BIN" message.
ENABLE ENERGY SAVER
Choose to have the tank heaters turn off, or reduce the
tank temp to (140° F) or (60° C) once the "SET IDLE
TIME" has expired. .5-50.0 hrs.
BREW COUNTS
Retains the total number of brew cycles completed.
There is one reset-able counter, and one life counter
that is not reset-able.
CALIBRATE FLOW
Measure and enter the actual fl ow rate coming out of
the sprayhead.
SERVICE TOOLS
Diagnostic tool for troubleshooting purposes only
FACTORY DEFAULTS
Reset all brew settings, calibrations back to factory pre-
sets. Requires following "INITIAL SETUP" procedure.
Refer to the "PROGRAMMING MANUAL" at www.bunn.
com for more advanced programming information.
Page 11
41167.2 121710