KYMCO PEOPLE S 50 2005 Owner's Manual page 51

This model adopts the battery which needs no refilling
of distilled water.
When cleaning the terminals, remove the screws
attaching the battery cover on the panel-foot and then
open the battery cover.
When battery terminals are corroded, take out the
battery for cleaning.
After cleaning, apply a thin coat of grease or vaseline
to battery terminals and then install the battery.
CAUTION:
Never open the closed-type battery electrolyte cap.
If the scooter will not be used for a long time, the
battery will discharge electricity by itself. Remove
the battery and put it in a cool place after it is fully
charged to prevent electricity leakage.
If the scooter will not be used for a long time,
remove the negative (-) terminal.
Do not smoke or allow flames or sparks near the
battery while removing and installing it.
Turn off the ignition switch before removal or
installation.
The negative (-) terminal shall be removed first
and the positive (+) terminal shall be installed first.
Tighten the loose terminal nuts securely.
Battery Charger
46