-
Change the switch to position REF (reading of the SWR level). The reading on
the Meter should be as near as possible to 1. If this is not the case, re-adjust
your antenna to obtain a reading as close as possible to 1. (An SWR reading
between 1 and 1.8 is acceptable).
-
It will be necessary to re-calibrate the SWR meter after each adjustment of
the antenna.
Your CB is now ready for use.
B) RANDY II P - PORTABLE CONFIGURATION
1) INSTALLATION
-
Screw the rubber antenna on the device.
-
Clip a full charged battery on the device. See page 11.
Your CB is now ready for use.
C) CONTROLS AND FUNCTIONS
1) ANTENNA: TNC type connector
2) PTT: "Push to Talk"switch
3) F: multi functions button
4) SQ: monitor function
5) LOCK / Down t / MENU: Key lock / Decrease a channel / Enter MENU when
F is held-pressed
6) SCAN / AM/FM / LIST: Scan function / AM/FM / Edit the Scan Channel List
7) LIGHT / P / DW: LCD backlight / Priority Emergency channel / Dual Watch
8) H/L / UP s / ROGER: TX power switch / Increase Channel / Roger Beep
9) MICROPHONE: Internal microphone
10) SPEAKER: Internal speaker
11) BELT CLIP
12) POWER SWITCH & VOLUME: On/Off setting and volume adjusting
5