Technical Characteristics - PRESIDENT Randy II Owner's Manual

REMOVE (See the figure 2)
2-1: To remove the battery pack, pull down the release latch on bottom.
2-2: Slide the battery pack away form the transceiver.
22) Frequency Display
At standby mode, press F (3) button shows the frequency
of the channel.
F) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (in mm)
- Weight
- Accessories supplied
- Filter
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel : inferior to 20 µW
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Internal speaker
: 40
: AM / FM
: from 26.965 MHz to 27.405 MHz
: 50 ohms
: 13.2 V (Randy II M) / 7.4 V (Randy II P)
: 54 (W) x 35 (D) x 120 (H) without accessories
: 319 g with accessories (Randy II M)
357 g with accessories (Randy II P)
: Adapter with antenna connector and
cigarette lighter plug (Randy II M)
Battery, rubber antenna and wall charger
(Randy II P)
: ANL (Automatic Noise Limiter)
: +/- 200 Hz
: 1 ~ 3 W AM / 1 ~ 4 W FM
: inferior to 4 nW (- 54 dBm)
: 300 Hz to 2.5 KHz
: 7 mV
: 1,8 A (with modulation power Hi)
: 2 %
: AM: 0.5 µV - 113 dBm / FM: 0.3 µV - 116 dBm
: 300 Hz to 2.5 kHz
: 60 dB
: 1 W
: min: 0.2 µV - 120 dBm / max: 1 mV - 47 dBm
: 8 ohms, 1 W
12