Randy Ii P - Portable Configuration; Control And Function - PRESIDENT Randy II M Owner's Manual

- Press the «push-to-talk» switch on the microphone to transmit.
- Bring the index needle to  by using the calibration key.
- Change the switch to position SWR (reading of the SWR level). The reading on
the Meter should be as near as possible to 1. If this is not the case, re-adjust
your antenna to obtain a reading as close as possible to 1. (An SWR reading
between 1 and 1.8 is acceptable).
- It will be necessary to re-calibrate the SWR meter after each adjustment of
the antenna.
Your CB is now ready for use.
B) RANDY II P - PORTABLE CONFIGURATION
1) INSTALLATION
- Screw the rubber antenna on the device.
- Clip a full charged battery on the device. See page 12.
Your CB is now ready for use.
C) CONTROLS AND FUNCTIONS
1) ANTENNA: TNC type connector
2) PTT: "Push to Talk"switch
3) F: multi functions button
4) SQ: Squelch On/Off
5) Lock / Down
/ MENU: Key lock / Decrease a channel / Enter MENU when F is held-pressed.
6) SCAN / A/F / Sc. list: Scan function / AM/FM / Edit the Scan Channel List
7) DW/ P / Lamp: Dual Watch / Priority Emergency channel / LCD backlight
8) H/L / UP s / RB : TX power switch / Increase Channel / Roger Beep
6