What To Do Before Calling For Service; July - Scotsman F0522 Installation And User Manual

Modular flaked & nugget ice machines
Table of Contents

Advertisement

N0422, F0522, N0622, F0822, N0922, F1222, N1322, F1522
Air, Water or Remote User Manual

What to do before calling for service

Normal Operation:
Ice
The machine will make either flaked or nugget ice,
depending upon the model. The ice will be
produced continuously until the bin is full. It is
normal for a few drops of water to occasionally fall
with the ice.
Heat
On remote models most heat is exhausted at the
remote condenser, the ice machine should not
generate significant heat. Water cooled models
also put most of the heat from ice making into the
discharge water. Air cooled models will generate
heat, and it will be discharged into the room.
Noise
The ice machine will make noise when it is in ice
making mode. The compressor and gear reducer
will produce sound. Air cooled models will add fan
noise. Some ice making noise could also occur.
These noises are all normal for this machine.
Reasons the machine might shut itself off:
Lack of water.
Steady Green
Blinking Green
Blinking Red
Yellow
Blinking Yellow -
Light Off
All Blinking
Indicator Lights & Their Meanings
Power
Status
Normal
Normal
Switching on or off.
Self Test
When Smart-Board
Failure
used, machine attention
recommended.
-
Diagnostic shut down
-
-
-
No power
Switched to Off
Unit is remotely locked out - check with leasing company

July 2009

Page 22
Does not make ice
Auger motor overload
High discharge pressure.
Low refrigeration system pressure.
Controller self test failure.
Check the following:
1. Has the water supply to the ice machine or
building been shut off? If yes, the ice machine will
automatically restart within minutes after water
begins to flow to it.
2. Has power been shut off to the ice machine? If
yes, the ice machine will automatically restart when
power is restored.
3. Has someone shut the power off to the remote
condenser while the ice machine still had power? If
yes, the ice machine may need to be manually
reset.
To Manually Reset the machine.
Push and release the Off button.
Push and release the On button.
To Shut the Machine Off:
Push and hold the Off button for 3 seconds or until
the machine stops.
Water
-
-
Lack of water
-
-
Normal
De-Scale &
Sanitize
-
-
-
Time to descale
and sanitize
In Cleaning
Mode
Normal

Advertisement

Table of Contents
loading

This manual is also suitable for:

F0822F1222F1522N0422N0622N0922 ... Show all

Table of Contents