Baffl E Installation/Adjustment; Leg Leveling System; Brick Installation - Quadra-Fire SAPPHIRE-MBK Owner's Manual

Figure 8.5 Install the vent pipe adapter with gasket or high-temp
silicone to the rear vent opening.
Figure 8.6 Place the grille gently into the opening on top of
the appliance.
D. Baffl e Installation/Adjustment
BAFFLE RETAINERS
Figure 8.7 Position baffl e on top of baffl e retainers on left and
right sides. Centering baffl e on retainers, ensure that the dark
painted bevelled edge and darker painted baffl e bottom side
faces toward the front viewing area of the fi rebox. Bend the
center tabs up to prevent the baffl e from sliding out.
30
BAFFLE
Quadra-Fire • Sapphire • 7055-116 Rev. G • 10/12
E. Leg Leveling System
Figure 8.8 Thread Allen bolts through nuts until fl ush.
NOTE: Two Allen bolts and two nuts are included in the
component bag. Normally, only one is required on the leg
not touching the fl oor.
Figure 8.9 Slide assembled nuts and bolts into slots on legs
with the nuts on the bottom.
Figure 8.10 Use a 5/32 in. 4mm) Allen wrench to adjust legs
up and down to desired level.
F. Brick Installation
There are two side bricks. Place the brick in position. The
top fl ange of the brick clip is positioned in a slot in the baffl e
bracket. The side brick fi ts behind the brick clip.
NOTE: The bricks need to be installed before placing the
logs in the fi rebox.
Baffle
Brick Clip
Brick - 2 on each side
This end goes in slot in baffle bracket
Brick Clip
Brick slips behind clip