Unit Connectors - Axis P1343 User Manual

Unit connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet. Using shielded cables is recommended.
Power connector - 2-pin terminal block used for power input.
Function Pin number
GND 1
DC Power 2
Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
Audio out (green) – Audio output (line level) that can be connected to a public address (PA) system or an active speaker with
a built-in amplifier. A pair of headphones can also be attached. A stereo connector must be used for the audio out.
SDHC memory card slot - A standard or high capacity SD memory card can be used for local recording with removable
storage.
To insert an SD card, lift the SD card cover on the rear of AXIS P1343/-E/AXIS P1344/-E, and carefully insert the SD card into
its slot.
To remove an SD card lift the cover and gently push the card in and release it. The SD card will come out of the slot and can
be removed.
Note:
Before removing the SD card, it should be unmounted to prevent corruption of recordings. To unmount the SD card, go
to Setup > System Options > Storage > SD Card > Disk Management and click Unmount.
Description
Ground
Power input 8-20V DC, max 6.4W.
AXIS P1343/-E/AXIS P1344/-E - Unit connectors
SD memory card slot
41
1 2