Table of Contents
Advertisement
Note: After setting the timezone, date and time, Figure 2 shall appear. The pre-registered
sensor will be shown, with temperature displayed as "--" or "Lo". If the sensor is still in the
casing, the reading will be shown as "--". Otherwise if the sensor has been taken out from
its casing for more than 30 seconds, you may see "Lo" after clicking the Refresh icon. If
you have warm up the sensor by rubbing it in you hands for more than a minute, click the
Refresh icon and you may see numerical temperature value displayed. Please refer to
the section on "How to Paste ThermoSensor" to know more about the correct pasting
method.
Click the "Home Page" icon
2.2
Setup II – Access Cadi.Sense Outside Your Home
Pre-Requisites:
Note: Please go through Section 2.1 before proceeding further.
You need to have a WiFi router which is already setup and connected to the internet.
You also need to know your WiFi router's SSID and password. Please check with your
internet service provider if you do not remember the SSID and/or password.
Step 1:
Click the "Advanced Settings" icon
"Advanced Settings" icon, please click the "Main Page" icon
"Connect to WiFi Router" icon. When a screen (see Figure 5) appears and asks "Please
select your WiFi router", click on your router's SSID, key in your router's password, then
click "Apply".
Figure 4
Advanced Settings
Menu
Note (a): Now please be patient as SmartNode needs about a minute to connect to
your WiFi router and another minute to reboot.
T-S1-800.900-I10-B01
and Figure 3 shall appear.
and Figure 4 will appear (if you cannot see the
Figure 5
Connecting to your
WiFi router
Cadi.Sense
User Manual
first).
Click the
Figure 6
Successful connection
8
Advertisement
Table of Contents
