Cadi.Sense Wireless Thermometer User Manual page 29

• Click the "Connect to WiFi Router" icon. When a screen appears and asks "Please
select your WiFi router", click on your router's SSID, key in your router's password, then
click "Apply". (Please be patient as SmartNode needs about a minute to connect to
your WiFi router and another minute to reboot.) Click Refresh if you don' t see your
router's SSID on the list.
Note (a): After successful connection to your WiFi router, SmartNode will remember the
router's SSID and password (unless you have intentionally unmarked the default "Remember
Settings" during connection).
automatically re-connect to your WiFi router, taking about 2 minutes.
Note (b): After successful connection to your WiFi router, you may not be able to use
"http://10.10.10.10" to access your SmartNode anymore. Nonetheless you can still access it
using the IP address assigned by your router.
Note (c): You may need to reboot (or unplug the Ethernet cable then plug in again) your
PC/laptop to connect to the SmartNode. You may need to enable Enhanced Compatibility
if you are using Windows 7 with certain brands of WiFi routers.
Use SmartNode as a WiFi Repeater
Once the WiFi connection from the SmartNode to your main router/AP is established you can
connect your WiFi devices like laptops and smartphones through the SmartNode SSID. These
devices will obtain an IP address from the main AP/router and should be able to access the
Internet from farther locations previously unreachable by your WiFi signal.
Configure SmartNode as a WiFi AP
SmartNode can also be configured as a WiFi Access Point to turn a regular modem-router
into a WiFi capable networking device to connect WiFi-enabled devices such as laptops and
smartphones.
T-S1-800.900-I10-B01
So if you were to switch off and on SmartNode, it will
Cadi.Sense
User Manual
29