Table of Contents
Advertisement
2.
How to Setup and Use Cadi.Sense
2.1
Setup I – Quick Setup
Pre-Requisites:
Get ready a mobile device (iPhone, Android phone, tablet or laptop). Write down the
information shown on your SmartNode plug here:
SSID (e.g., CADI_XXXX):
PWD (8 chars):
SmartNode ID:
Step 1:
Plug in the SmartNode to a power socket in the same room where the patient will be
resting. Then switch it on. (Note: SmartNode takes about 30 secs to start up.)
Step 2:
Turn on WiFi on your mobile device. Then connect it to SmartNode using the above SSID
and password (PWD, 8 chars).
Step 3:
Go to web browser and enter:
http://10.10.10.10
If Figure 1 appears, select your timezone and click "Save". Otherwise Figure 2 shall
appear. Quick setup is done!
Figure 1
Setting date, time
and timezone
T-S1-800.900-I10-B01
Figure 2
Main Page
(Sensor Selection)
Cadi.Sense
User Manual
Figure 3
Home Page
(Temperature Monitoring)
7
Advertisement
Table of Contents
