Application; Providing Power To The Thermostat - Robertshaw RS6110 User Manual

Application

The Robertshaw 6000 family of thermostats is designed to control gas,
electric, oil, heat pump, and millivolt heating and electric cooling systems.
The RS6110 is a single stage thermostat while the RS6220 is a two-stage
thermostat.
The RS6000 thermostats can have a schedule programmed for each day.
!
IMPORTANT SAFETY INFORMATION
WARNING:
• Always turn off power at main fuse or circuit breaker panel before
installing, removing, cleaning, or servicing thermostat.
• Read all the information in this manual before installing this
thermostat.
• This is a 24V AC low-voltage thermostat. Do not install on voltages
higher than 30V AC.
• All wiring must conform to local and national building and electrical
codes and ordinances.
• Do not short (jumper) across terminals on the gas valve or at the
system control to test installation. This will damage the thermostat
and void the warranty.
• Do not connect ground to any terminal in this unit.
• This thermostat is configured with automatic compressor protection
to prevent damage because of short cycling or extended power
outages. Short cycle protection provides a delay between heating
and cooling cycles on heat pumps.
Detailed mounting and wiring instructions are explained in the Installation
Manual.
Refer to the pop up wizard section in the installation manual for a
complete list of factory defaults and contractor settings.

Providing Power to the Thermostat

For wiring diagrams refer to the Installation Manual.
The thermostats will operate using 24V AC or two AA batteries. When the
two AA batteries are installed the thermostat will continue to run if the
24V AC fails.
2