Mounting; Orientation; Rigging - Chauvet COLORado 1 tour User Manual

Setup

Mounting

Orientation

Rigging

Procedure
Product Mounting
Diagram
-8-
Before mounting this fixture, read and follow the safety recommendations indicated in
the Safety Notes section (page 2 of this manual).
Always mount this fixture in any safe position while making sure that there is adequate
room around it for ventilation, configuration, and maintenance.
Make sure to mount this fixture away from any flammable material as indicated in the
Safety Notes section.
The COLORado™ 1 Tour consists of a sealed housing with a double bracket mounting
yoke. It has two DMX signal sockets (DMX In/out), and two NEUTRIK® powerCON
connectors (Power In/Out).
CHAUVET® recommends following the general guidelines below when mounting the
COLORado™ 1 Tour.
•
When selecting an installation location, consider ease of access to the fixture for
operation, programming adjustments, and routine maintenance.
•
Never mount the fixture in places where rain, high humidity, extreme temperature
changes, or restricted ventilation may affect it.
•
If hanging this fixture, make sure that the location where you are mounting the
fixture can support its weight. Please see the Technical Specifications section of this
manual for the weight requirement of this fixture.
The COLORado™ 1 Tour includes a mounting yoke to which you can attach one or two
rigging clamps. You must supply your own "C" or "O" clamps and make sure that they
are capable of supporting the weight of this fixture. CHAUVET® recommends using at
least two mounting points per fixture.
Overhead Mount
Floor Mount
Secure the safety cable using the
passageway on the back of the fixture.
COLORado™ 1 Tour User Manual Rev. 01h