Table of Contents
Advertisement
The Magellan eXplorist Pro 10 can be connected to a personal computer or
external power using the USB connector located at the bottom of the receiver in
the back. It has a rubber cover to protect the connector from water or dirt and
should always be closed firmly when not being used to connect the receiver to a
remote device.
Accessing the USB Connector
Using your fingernail at [B], open the USB
Port cover. When done, be sure to close
the cover firmly to prevent water or dirt from
entering the USB port. (Note that the USB
connector is angled up slightly.)
Applying External Power
The receiver can be powered from an external 12 VDC source using a
Magellan-approved VPA (Vehicle Power Adapter) or by connecting it to a
personal computer using a standard USB cable. If connecting to a vehicle
receptacle, connect the VPA to the USB connector on the receiver and the other
end to a vehicle 12 VDC power receptacle. (Note: Some power receptacle's
apply 12 VDC only when the vehicle ignition is on.)
Touch Pro 10 QSG.indd 5
Connecting to the USB Port
B
1/11/2011 10:11:40 AM
Advertisement
Table of Contents
