Connecting Power; Checking Connection And Final Adjustments; Power Button; Security - Magellan RoadMate Pro 5190T User Manual

Navigation device

Table of Contents

Connecting Power

Plug the end of the vehicle power adapter into a 12VDC vehicle power

receptacle. Be sure to avoid routing the power cable over airbags.

Note: Some vehicles apply power to the vehicle power receptacle only when

the ignition is on.

If the power indicator light on the vehicle power adaptor is on, power is being

supplied to the Magellan RoadMate receiver. If it is not on, check the cable

connection to the vehicle power receptacle. If the light is still not on, turn the

vehicle's ignition on.

Press the power button to turn the receiver on or off (suspend mode). Suspend

mode allows the receiver to turn on quickly the next time you use it. However,

if you want to turn the receiver completely off, press the power button and hold

for 3 seconds or more. (Turning the receiver completely off and then back on

[Power Reset] can sometimes solve any problems encountered while using

the receiver.)

It is recommended that the Magellan RoadMate receiver is not left in plain

view while unattended for reasons of theft.

Please note that the Magellan RoadMate receiver is a receiver only and does

not transmit GPS location signals. Neither the receiver nor the vehicle can be

tracked using the Magellan RoadMate receiver.

Table of Contents

Roadmate rc5190t