Heat Sink - HP EliteBook 2570p Maintenance And Service Manual

8. Remove the system board (3) by sliding it up and to the left at an angle.
9. Remove the system board.
Reverse this procedure to install the system board.

Heat sink

Description
Heat sink (includes replacement thermal material)
Before removing the heat sink, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Bluetooth module (see
c. Speaker assembly (see
d. Optical drive (see
e. Hard drive (see
f. Fan (see
Battery on page
Service cover on page
Bluetooth module on page
Speaker assembly on page
Optical drive on page
Hard drive on page
Fan on page 60)
50), and then remove the following components:
52)
54)
56)
57)
58)
Component replacement procedures
Spare part number
685508-001
81