g.
WWAN module (see
h.
Modem module (see
i.
Keyboard (see
j.
Base enclosure (see
k.
System board (see
Remove the heat sink:
1.
Following the 1, 2, 3, 4 sequence stamped into the heat sink, loosen the four captive Philllips
screws (1) that secure the heat sink to the system board.
82
Chapter 4 Removal and replacement procedures
WWAN module on page
Modem module on page
Keyboard on page
69)
Base enclosure on page
System board on page
61)
68)
74)
79)