f.
Fan (see
Fan on page
g.
WWAN module (see
h.
Modem module (see
i.
Keyboard (see
j.
Base enclosure (see
k.
System board (see
l.
Top cover (see
Remove the Smart Card reader assembly:
1.
Release the function LED board (1) from the clips built into the top cover.
2.
Release the ZIF connectors to which the TouchPad board cables are connected, and then
disconnect the TouchPad cables (2) and (3) from the Smart Card reader assembly.
3.
Release the Smart Card reader assembly cable (4) from the clips (5) built into the top cover.
4.
Remove the Phillips PM2.0×2.5 broad head screw (1) that secures the Smart Card reader
assembly to the top cover.
60)
WWAN module on page
Modem module on page
Keyboard on page
69)
Base enclosure on page
System board on page
Top cover on page
87)
61)
68)
74)
79)
Component replacement procedures
93