Px-850A Quickstart Installation - Plextor PX-850A Installation And User Manual

Section 2. Installing the PX-850A Internal PATA Drive

PX-850A QuickStart Installation

For Experienced PC Users Only
If you've installed computer peripherals before, use this QuickStart
installation to get up and running quickly.
IMPORTANT NOTE: To ensure maximum writing speed, you must
connect the PX-850A to an 80-conductor IDE/ATA flat ribbon cable.
(This newer 80-conductor ribbon cable is physically interchangeable
with the 40-conductor cable found in older computers.)
Typical Scenario 1: You have a PC with an IDE interface installed,
you have Windows Vista or XP and you have nothing installed on the
secondary IDE port. What to do: Leave the PX-850A's jumper set to
Master, attach it to the secondary IDE port, and go. Windows will
recognize the drive automatically.
Typical Scenario 2: You have a PC with an IDE interface installed,
you have Windows Vista or XP the primary IDE port already has two
devices connected and you have a CD-ROM installed on the
secondary IDE port. What to do: Change the CD-ROM to Slave,
leave the PX-850A's jumper set to Master and attach the PX-850A to
the secondary IDE port. Windows recognizes the new drive
automatically.
If neither of these situations applies to you, or you're not comfortable
with IDE installation, read the rest of this section for more detailed
installation instructions.
12
PX-850 Installation and Users Manual