Wired/Wireless Remote Shutter Release - Yongnuo RF-603 User Manual

Wired/wireless remote shutter release

This product may achieve wired remote shutter release/
wireless remote shutter release, in support of single frame,
continuous photograph, delay and bulb shooting modes.
And the modes shall be set on the camera before using.
Additional YongNuo 2.5mm shutter connecting cable needs
to be purchased.
1. Single transceiver can be used as a wired remote
shutter release.Press the release button halfway of the
transceiver to focus, press completely to shoot, the
EN shutter indicator light will turn on(red).
2. When it is used as wireless remote shutter release, fix
one transceiver on the hot shoe or near the camera,and
hold the other transceiver.As shown in the figure, press
the shutter release button halfway of the transceiver
which on your hand, and the camera will focus, press
the button completely to shoot, meanwhile, the shutter
indicator light will turn on( red).
9
Connected the shutter
connecting cable as
shown in the figure.