Advertisement
Advertisement
Table of Contents
Related Manuals for Yongnuo Speedlite YN468-II
Summary of Contents for Yongnuo Speedlite YN468-II
- Page 1 USER MANUAL...
-
Page 2: Parts List
I. Caution To avoid fire or electrical shock, do not expose this product to rain or moisture. Do not flash at high level output continuously for over 15 times. To avoid short circuit, be sure the batteries contacts are securely packed and in accordance with local provision when handling the batteries. -
Page 3: Lcd Panel Description
9. LCD panel 10. +/- buttons 11. Power Switch (ON/OFF) 12. Mode switch button 13. PC port 14. Charging indicator 15. Test button LCD panel description 16. Mode indicator 17. Output/EV indicator 18. AF LED switch indicator 19. Aperture indicator 20. -
Page 4: Installation Instruction
III. Installation Instruction 1. Install Batteries Slide the batteries chamber’s cover in the direction of the arrow. Insert the batteries according to the label inside battery chamber. Make sure the direction of the batteries’ polarity is correct. Close the battery chamber cover in the direction of the arrow. - Page 5 Under the M, Multi, S1 and S2 modes, the output power of the flash light can be adjusted through this button Under the Multi mode, this button can also be used to adjust the time of the frequency flash and the frequency. Please refer to the section of Multi mode.
- Page 6 available. Continue turning the knob to make the flash light enter M mode and adjust flash power. If the charging indicator keeps green for more than 20 seconds, the flash will power off automatically. After use, the power of the flash light can be closed by pressing this button for 2 seconds.
- Page 7 6. S1/S2 Mode Press the [MODE] button, then the flash will enter S1/S2 mode. These modes are applicable for slave flash in order to create many light effects. They are respectively applicable for manual flash environment and TLT flash environment. When the flash is in S1 mode, it will work with the first work of the master flash synchronously, with the result consistent with the use of radio slave.
-
Page 8: Advanced Application
10. Overheating Protection If the flash light is used too frequently, its overheating protection function will be triggered, the red and green lights of the charging indicator will blink alternatively, and the flash light will be locked. In such case, please wait for three minutes to cancel the protection before continuing the use. - Page 9 after 3 photos are taken, exposure compensation will be made automatically in the sequence of, for example, “normal under over”. This function helps you improve the success rate of photo taking. 3. FV Lock (Nikon) Set the AE-L/AF-L function as FV Lock on the camera before using this function.
- Page 10 brightness with the [Output control knob] within the range of ±3ev, with the precision of 1/3ev. Please Note that this compensation setting will override the exposure compensation setting on the camera. 8. Reflection Flash Bounce flash means to take photos by making flash light head aimed at wall or ceiling and using the light reflected back from the ceiling or wall to light the desired object, so that the shade behind the object can be decreased to get more natural shooting effect.
-
Page 11: Troubleshooting
VI. Specifications Guide number Circuit design Insulated Gate Bipolar Transistor (IGBT) Flash mode TTL, M, Multi, S1, S2 Zoom range auto, 24, 28, 35, 50, 70, 85 mm Vertical rotation angle -7~90 degrees Horizontal rotation angle 0~270 degrees Power Supply 4×AAsize batteries (Alkaline or Ni-MH are usable) Lighting times... - Page 12 (Nikon) or wireless mode (Canon) of the main light is used; the ST-E2 is used as the flash controller. The YONGNUO logo in this manual includes the registered trademark trademark...