Hardware Installation - D-Link DCS-3420 User Manual

Section 1 - Product Overview

Hardware Installation

If your are connecting the DCS-3420 to a wired Ethernet network, connect an
Ethernet cable to the network cable connector located to the network cable connector
located on the camera's back panel and attach it to the network.
Note: It is required that an Ethernet cable is used during initial setup. Once your
wireless configuration is set, you may disconnect the Ethernet cable and begin
communicating wirelessly with your DCS-3420.
Locate the antennas included with your DCS-3420 and attach them to the antenna
connectors located on the back of the DCS-3420.
Attach the external power supply to the DC power input connector located on the
Internet Camera's back panel (labeled 12VDC) and connect it to your wall outlet.
Note: When you have a proper connection, the LED will turn from red to green.
The light may cycle on and off and your computer may show an intermittent loss of
connectivity, this is normal until you have configured your Internet Camera.
D-Link DCS-340 User Manual