Installing The Light Kit - Hunter Ceiling Fans Installation And Operation Manual

7 • Installing the Light Kit
Steps 7-1 – 7-2
Housing
Assembly
Screw
10
Steps 7-3 – 7-4
Socket Assembly
Hunter Fan Company
WARNING: Use only the light fixture supplied with this fan model.
7-1. To attach the upper light kit assembly, partially install two #6-32 x
3/8" housing assembly screws into the switch housing mounting
plate.
7-2. Feed the upper plug connector through the center opening of the
assembly.
7-3. Align the keyhole slots in the assembly with the housing assembly
screws.
7-4. Turn the assembly counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole slots.
Upper
Install the remaining #6-32 x 3/8" screw into the housing. Tighten
Light Kit
Assembly
all three screws firmly.
CAUTION: Make sure the upper light kit assembly is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the switch
housing and light fixture falling.
7-5. To attach the light kit, connect the upper plug connector from the
motor to the lower plug connector in the socket assembly.
Note: Both plug connectors are polarized and will only fit together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
operation and damage to the product.
7-6. Place the socket assembly inside the upper light kit assembly.
Align the side screw holes. Attach the fitter to the upper assembly
with two #6-32 x 3/8" assembly screws.
Plug
Connector
Detail
Step 7-6
Housing
Assembly
Screw
42500-01 • 11/28/05