Installing The Light Kit - Hunter 42625-01 Installation And Operation Manual

7 • Installing the Light Kit
Steps 7-1 – 7-3
Keyhole
Slot
10
Housing
Assembly
Screw
WARNING: Use only the light fixture supplied with this fan model.
7-1. To attach the upper switch housing, partially install two #6-32 x
3/8" housing assembly screws into the switch housing mounting
plate.
7-2. Feed the upper plug connector through the center opening of the
housing.
7-3. Align the keyhole slots in the housing with the housing assembly
screws.
7-4. Turn the housing counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole slots.
Install the remaining #6-32 x 3/8" screw into the housing. Tighten
all three screws firmly.
CAUTION: Make sure the upper switch housing is securely
Upper
Switch
attached to the switch housing mounting plate. Failure to properly
Housing
attach and tighten all three assembly screws could result in the
switch housing and light fixture falling.