Installing The Light Kit - Hunter Type A Installation And Operation Manual

6-1. Partially install two screws into the mounting plate.
6-2. Route the wires into the wire channel and connect the plug
connector from the light kit to the plug connector from the
fan.
WARNING:
Rotate the wire protector tab above the wires to keep the
wiring harness from coming out of the wire channel.
Wire protector tab must be inserted under the opposite side
of the channel. Failure to do so may result in electrical
shock and/or product damage.
6-3. Place the light kit against the mounting plate and align the
holes with the partially installed screws. Rotate the light kit to
situate the screws in the narrow ends of the keyholes. Install
the remaining screw and securely tighten all three.
6-4. Install two 60 Watt max (Type B10) candelabra base bulbs
into the sockets.
6-5. Align the arrow on the glass with the arrow in the mid-body
housing. Rotate the glass clockwise to engage the tabs.
Light Kit Screw
6 • Installing the Light Kit
Step 6-3
Light Kit Screw
9
42815-01 • 10/02/07 • Hunter Fan Company
Wire Protector Tab
Wire Channel
Arrows
Step 6-5
Step 6-2
Step 6-4