Assembling And Hanging The Fan - Hunter Ceiling Fans Installation And Operation Manual

3 • Assembling and Hanging the Fan
Steps 3-1 – 3-2
Steps 3-3 – 3-4
6
#8-32 x 1" Screw
Hunter Fan Company
You can assemble your fan for standard mounting (steps 3-1 – 3-2) or
for low profile mounting (steps 3-3 – 3-4).
Downrod
3-1. To assemble fan to hang down from a flat or angled ceiling, insert
Canopy
3-2. Screw the downrod into the fan assembly. Tighten the set screw.
Canopy
Trim Ring
Set Screw
3-3. Place the low profile washer (lip up) into the canopy. Be sure the
Low Profile Washer
3-4. Align the holes in the washer with the holes in the adapter.
3-5. Raise the fan and place the hook on the ceiling plate through the
the downrod through the canopy and canopy trim ring. Feed the
wires from the fan through the downrod.
Skip to Step 3-5.
CAUTION: e downrod has a special coating on the threads.
Do not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
green ground wire is pointing up toward the ceiling.
Note: For low profile mounting, the downrod is replaced with the
low profile washer. See Steps 3-3 – 3-4.
Assemble securely with three #8-32 x 1" screws.
U-shaped hole in the rim. Go to 4 • Wiring the Fan.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Step 3-5
U-shaped
Hole
41884-01 • 10/13/04