Completing Your Installation With Or Without A Light Fixture - Hunter Ceiling Fans Installation And Operation Manual

7 • Completing Your Installation With or Without a Light Fixture
Your Hunter fan comes with an integrated light fixture assembly and an
optional switch housing cap and finial. is feature gives you the option
of installing the fan with OR without the included light fixture. e
steps below direct you whether or not you are installing a light fixture.
7-1. To attach the upper switch housing, partially install two #6-32 x 3/8"
housing assembly screws into the switch housing mounting plate.
7-2. Feed the upper plug connector through the center opening of
the housing.
7-3. Align the keyhole slots in the housing with the housing assembly
screws.
7-4. Turn the housing counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole slots.
Install the remaining #6-32 x 3/8" screw into the housing. Tighten
all three screws firmly.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the switch
housing and light fixture falling.
7-5. If you want to install the light fixture, proceed with step 7-6 now.
If you do not want to install the light fixture, you need to uninstall
it now. See "Uninstalling the Light Fixture" on page 13. Once you
have uninstalled the light fixture, complete steps 7-6 – 7-7.
7-6. To attach the lower switch housing, connect the upper plug
connector from the motor to the lower plug connector in the
lower switch housing assembly.
Note: Both plug connectors are polarized and will only fit
together one way. Make sure the connectors are properly aligned
before connecting them. Incorrect connection could cause
improper operation and damage to the product.
7-7. Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower
switch housings. Attach the lower switch housing to the upper
switch housing with three #6-32 x 3/8" housing assembly screws.
42024-01 • 10/25/05
Steps 7-1 – 7-4
Housing
Upper
Assembly
Switch
Screw
Housing
Steps 7-6 – 7-7
Lower
Switch
Housing
Housing
Assembly
Screw
Hunter Fan Company
11
Plug
Connector