Setup; Ac Power - Chauvet Intimidator Sport LED 150 User Manual

3. S
ETUP

AC Power

This product has an auto-ranging power supply and it can work with an input voltage
range of 100~240 VAC, 50/60 Hz.
To determine the power requirements for a particular fixture, see the label affixed to
the back plate of the fixture or refer to the fixture's specifications chart. A fixture's
listed current rating indicates its average current draw under normal conditions.
Power Linking
Power Linking
Diagram
You can power link up to 11 Intimidator™ Spot LED 150 units on 120 VAC or up
to 20 Intimidator™ Spot LED 150 units on 230 VAC.
The power linking diagram shown above corresponds to the North American
version of this product ONLY! If using this product in other markets, you must
consult with the local CHAUVET® distributor as power linking connectors and
requirements may differ in your country or region.
Intimidator™ Spot LED 150 User Manual (Rev. 01g)
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit,
even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
This fixture provides power linking via the Edison outlet located in the back of the unit.
Please see the diagram below for further explanation.
Generic Fixture Housing
st nd
1 Fixture 2 Fixture
rd
3 Fixture
Other fixtures
Page 7 of 20