Table of Contents
Advertisement
3. S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. An 800W halogen lamp is
included.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
Lamp Installation
1)
Unscrew the two thumbscrews (Figure 1).
2)
Gently remove the lamp housing from the
fixture.
3)
Remove the lamp from the socket (Figure 2)
4)
Hold the new lamp with a lint-free cloth.
Insert lamp into socket.
5)
Carefully reinsert lamp housing into the
fixture.
6)
Tighten both thumbscrews
Note:
It may be necessary to align the lamp after
replacement. See the "Lamp Alignment"
section on the next page for instructions on
how to do this.
SX Gobo Manual
1
2
6
2006-12-11/15:16
Advertisement
Table of Contents
