Ending A Call; Adjusting Handset Receiver (Earpiece) Voice Volume; Adjusting Handset Speakerphone Voice Volume; Placing A Call On Hold - EnGenius FreeStyl V2 User Manual

Ending a Call

To end a telephone or intercom call, press
cradle.

Adjusting Handset Receiver (Earpiece) Voice Volume

1. Voice volume can only be adjusted during a call.
2. There are 6 levels of volume selections. Use
key to adjust
3. The new setting remains effective for all future calls until
changed.

Adjusting Handset Speakerphone Voice Volume

1. Voice volume can only be adjusted during a call (in
speakerphone mode).
2. There are 6 levels of volume selections. Use
key to adjust
3. The new setting remains effective for all future calls until
changed.

Placing a Call On Hold

1. When a call is in progress, it can be put on hold by pressing
the key.
2. To return to the conversation, press
Notes:
1. The call being placed on hold can be "un-hold" by the handset
that puts it on hold. But if after you press the
key, or place handset into charger
or
or
UNHOLD (Left) soft key
key to go
~33~
back to standby, then other handsets can press
pick this held call (If you press
pick up this held call).
2. Handset LCD displays a call is on hold. An alert tone (double
beep) will occur every 30 seconds to remind the handset user
that a call is still on hold.
3. If the operation (e.g., call transfer) after putting a call on-hold
fails, the held call may be dropped.

Mute

1. After a link is established, you can press
key to mute the handset microphone.
2. When mute is active, the other end will not hear your
voice, but still can speak to you.
3. To leave the mute state, press UNMUTE
for the current call.

Do Not Disturb (Silent Ring)

1. Enter the key sequence MENU-3-1, then select "Off". Press
SELECT (Left) soft key to confirm your choice. This will turn
off the ringer until it is turn on again from the menu.
Re: When setting the ringer "Off", the standby screen will
show "Ringer off".
2. For temporary silencing the ringer when an incoming call
arrives, press SILENT (Left) soft key.

Key Guard

1. To prevent accidental dialing, you can press
soft key, then press"1" to select the KeyGuard option. The
handset keypad is locked. No key entry will be accepted.
or to
on the base, you can also
MUTE (Left) soft
(Left) soft key. Mute is effective only
MENU (Right)
~34~